Universal 30mm Grinder Cup Riser for 3" Dosing Cups & Blind Shakers

$7.99 USD

Sale Sold out

Shipping calculated at checkout.

Bring your dosing cup or blind shaker closer to your grinder's chute with a simple, stable platform designed for 3-inch cups.

The Grind to Brew Co. Universal Grinder Cup Riser raises your receiving cup by 30 mm (3 cm / 1.18 in), helping reduce the open space between the grinder's chute and the cup.

Unlike our grinder-specific accessories, this riser uses a standalone design that makes it suitable for a variety of coffee grinder setups where the available tray space can accommodate its dimensions.

Made for 3" Dosing Cups & Blind Shakers

The riser is designed around dosing cups and blind shakers approximately 3 in / 75 mm wide.

The platform measures approximately:

Base Width: 90 mm / 9 cm / 3.54 in
Cup Inset: 80 mm / 8 cm / 3.15 in
Rise: 30 mm / 3 cm / 1.18 in

The recessed area provides a defined bed for your cup, helping keep it positioned beneath the grinder while grinding.

Two Designs Available

Choose the version that works best for your coffee workflow.

Full Inset

The cup bed is surrounded on all sides, creating a defined recessed area for the dosing cup or blind shaker to sit inside.

Simply place your cup into the recessed bed before grinding.

Front-Entry

The retaining edge runs along the sides and back while leaving the front open.

This allows the dosing cup or blind shaker to slide into the riser from the front, which can be especially convenient when clearance beneath the grinder makes lifting the cup in and out less practical.

Designed for Grinder Trays

The riser has a rounded front and squared, flat back, allowing the rear of the platform to sit neatly toward the grinder while maintaining a softer profile at the front.

Because this is a universal accessory, please measure your grinder's available tray area before ordering.

Your grinder should have sufficient space for the approximately 90 mm-wide base, as well as adequate clearance above the riser for your cup.

Features

Raises your cup 30 mm / 3 cm / 1.18 in
Designed for approximately 3" / 75 mm dosing cups and blind shakers
90 mm-wide base
80 mm-wide cup inset
Recessed cup bed helps position the cup while grinding
Available with a full retaining inset or front-entry design
Front-entry version allows the cup to slide in from the front
Rounded front profile
Squared, flat back
Standalone design for use with compatible grinder trays
No permanent grinder modification required
Original Grind to Brew Co. design
3D printed

Please Measure Before Ordering

This is a universal-fit accessory and is not designed to guarantee compatibility with every grinder.

Before ordering, please measure your grinder's tray area and available vertical clearance to make sure the riser and your cup will fit your setup.

Material & Care

This product is 3D printed and should be cared for accordingly.

Clean with a soft, damp cloth or hand wash with cool or lukewarm water and mild soap when necessary. Do not place in the dishwasher, microwave, or expose to boiling water.

Keep away from open flames, hot surfaces, and other sources of excessive heat. Allow the product to dry completely before returning it to your coffee setup.

Due to the nature of 3D printing, minor layer lines and small surface variations may be visible. These are normal characteristics of the manufacturing process and are part of the 3D-printed finish.